Home > Communication Electronics > CW Transmitters
Sort By:
Page of 1
Texas Star Modulator V Plus
List Price: $185.00
Our Price: $185.00

  • 1X2290 RF Transistor
  • Class C
  • 100 Watts Variable Output
  • Great Driver Unit!
  • 10 DB Receive Preamp
  • Draws Approx. 14 Amps



*These units are for industrial, scientific, medical, or export use only. It is a violation of US FCC regulations to operate these units on the Citizens Band or Amateur Radio Services in the United States. Please check regulations in your country before operating these unit.
Texas Star DX 1600 1200 FAN KIT
Our Price: $199.00

Fan Kit for Texas Star 1600 and 1200 amps.
Texas Star DX 400V 400W Mobile
Our Price: $425.00

  • 400W/40A
  • 4-2SC2990
  • Variable Power W/SSB Delay
  • Meter



*These units are for industrial, scientific, medical, or export use only. It is a violation of US FCC regulations to operate these units on the Citizens Band or Amateur Radio Services in the United States. Please check regulations in your country before operating these unit.
Texas Star DX 500V 500W Mobile
Our Price: $460.00

  • 5000W/62A
  • Variable Power W/SSB Delay
  • Meter-RF Relative Output Indicator and lights during transmission

OPERATION:
  • Red "POWER" Button turns the unit on and off.
  • White "REC AMP" Button turns the receive amplifier on to provide 6dB of gain for your receiver. This will work independently of the power button -- that is, the white button may be pressed "on" even when the red button is "off." The oscillator may be operated without any output to the antenna. You will be able to hear the signal in your receiver. This may be useful to adjust your electronic keyer or to practice your Morse Code "off the air."
  • Green Button reduces power on all models. On models DX 400V and DX 500V, it also activates the RF Output Knob.
  • Yellow "DELAY" Button reduces power and adds delay to the transmit/receive relay to accommodate different transmission rates for break-in keying operation. On models DX 400V and DX 500V, this button adds delay but does not reduce power.
  • RF Output Knob controls RF output level when the Green Button is engaged. On the DX 667V only, the RF Output knob is operational at all times.
  • Meter is an RF Relative Output Indicator and lights during transmission.
  • A Crystal made for series operation must be installed into the holes labeled "X-1" near the top of the oscillator board. The frequency should fall between 28.0 MHz and 29.7 MHz.
  • Key Jack for 1/8" miniature phone plug is located on the rear of the unit for connection of the telegraph key.
  • Power Cables are also located at the rear. The red lead connects to the positive side of the power supply, and the black lead connects to the negative side.
  • Antenna Connector (SO239) for 50 ohm antenna is located on the rear.
  • Radio Connector (SO239) for 50 ohm output to the receiver is also located on the rear.

SPECIFICATIONS:
Frequency Range : 28.0 MHz to 29.7 MHz
Stability : 50 parts per million, 0-50 degrees Celsius with typical quartz crystal
Power Output : < 5 watts
Voltage : 13.6 volts DC
Amps : < 6
Impedance : 50 ohms
Duty Cycle : 100% at full output
Harmonics : > 30dB down
Dimensions : 3-1/4"(H) x 6-5/8"(W) x 10-3/4"(D)
Weight : 6 pounds

*These units are for industrial, scientific, medical, or export use only. It is a violation of US FCC regulations to operate these units on the Citizens Band or Amateur Radio Services in the United States. Please check regulations in your country before operating these unit.
Texas Star DX 667V 750W Mobile
Our Price: $495.00

  • 750W/62A
  • Variable Power W/SSB Delay
  • Meter-RF Relative Output Indicator and lights during transmission

OPERATION:
  • Red "POWER" Button turns the unit on and off.
  • White "REC AMP" Button turns the receive amplifier on to provide 6dB of gain for your receiver. This will work independently of the power button -- that is, the white button may be pressed "on" even when the red button is "off." The oscillator may be operated without any output to the antenna. You will be able to hear the signal in your receiver. This may be useful to adjust your electronic keyer or to practice your Morse Code "off the air."
  • Green Button reduces power on all models. On models DX 400V and DX 500V, it also activates the RF Output Knob.
  • Yellow "DELAY" Button reduces power and adds delay to the transmit/receive relay to accommodate different transmission rates for break-in keying operation. On models DX 400V and DX 500V, this button adds delay but does not reduce power.
  • RF Output Knob controls RF output level when the Green Button is engaged. On the DX 667V only, the RF Output knob is operational at all times.
  • Meter is an RF Relative Output Indicator and lights during transmission.
  • A Crystal made for series operation must be installed into the holes labeled "X-1" near the top of the oscillator board. The frequency should fall between 28.0 MHz and 29.7 MHz.
  • Key Jack for 1/8" miniature phone plug is located on the rear of the unit for connection of the telegraph key.
  • Power Cables are also located at the rear. The red lead connects to the positive side of the power supply, and the black lead connects to the negative side.
  • Antenna Connector (SO239) for 50 ohm antenna is located on the rear.
  • Radio Connector (SO239) for 50 ohm output to the receiver is also located on the rear.

SPECIFICATIONS:
Frequency Range : 28.0 MHz to 29.7 MHz
Stability : 50 parts per million, 0-50 degrees Celsius with typical quartz crystal
Power Output : < 5 watts
Voltage : 13.6 volts DC
Amps : < 6
Impedance : 50 ohms
Duty Cycle : 100% at full output
Harmonics : > 30dB down
Dimensions : 3-1/4"(H) x 6-5/8"(W) x 10-3/4"(D)
Weight : 6 pounds

*These units are for industrial, scientific, medical, or export use only. It is a violation of US FCC regulations to operate these units on the Citizens Band or Amateur Radio Services in the United States. Please check regulations in your country before operating these unit.
Texas Star DX 500V 500W Mobile W/ Toshiba Transistors
Our Price: $550.00

  • 500W/62A
  • Toshiba Transistors
  • Variable Power W/SSB Delay
  • Meter-RF Relative Output Indicator and lights during transmission

OPERATION:
  • Red "POWER" Button turns the unit on and off.
  • White "REC AMP" Button turns the receive amplifier on to provide 6dB of gain for your receiver. This will work independently of the power button -- that is, the white button may be pressed "on" even when the red button is "off." The oscillator may be operated without any output to the antenna. You will be able to hear the signal in your receiver. This may be useful to adjust your electronic keyer or to practice your Morse Code "off the air."
  • Green Button reduces power on all models. On models DX 400V and DX 500V, it also activates the RF Output Knob.
  • Yellow "DELAY" Button reduces power and adds delay to the transmit/receive relay to accommodate different transmission rates for break-in keying operation. On models DX 400V and DX 500V, this button adds delay but does not reduce power.
  • RF Output Knob controls RF output level when the Green Button is engaged. On the DX 667V only, the RF Output knob is operational at all times.
  • Meter is an RF Relative Output Indicator and lights during transmission.
  • A Crystal made for series operation must be installed into the holes labeled "X-1" near the top of the oscillator board. The frequency should fall between 28.0 MHz and 29.7 MHz.
  • Key Jack for 1/8" miniature phone plug is located on the rear of the unit for connection of the telegraph key.
  • Power Cables are also located at the rear. The red lead connects to the positive side of the power supply, and the black lead connects to the negative side.
  • Antenna Connector (SO239) for 50 ohm antenna is located on the rear.
  • Radio Connector (SO239) for 50 ohm output to the receiver is also located on the rear.

SPECIFICATIONS:
Frequency Range : 28.0 MHz to 29.7 MHz
Stability : 50 parts per million, 0-50 degrees Celsius with typical quartz crystal
Power Output : < 5 watts
Voltage : 13.6 volts DC
Amps : < 6
Impedance : 50 ohms
Duty Cycle : 100% at full output
Harmonics : > 30dB down
Dimensions : 3-1/4"(H) x 6-5/8"(W) x 10-3/4"(D)
Weight : 6 pounds

*These units are for industrial, scientific, medical, or export use only. It is a violation of US FCC regulations to operate these units on the Citizens Band or Amateur Radio Services in the United States. Please check regulations in your country before operating these unit.
Texas Star DX 1600 Mobile
Our Price: $849.00

  • 100W Input
  • 1200W Output
  • DEI 8-2SC2879
  • SSB Delay

*These units are for industrial, scientific, medical, or export use only. It is a violation of US FCC regulations to operate these units on the Citizens Band or Amateur Radio Services in the United States. Please check regulations in your country before operating these unit.
Texas Star DX 1600X Mobile
Our Price: $1,000.00

  • 8-2SC2879
    100 Watt Input
    1200 Watt Ouptput Power
    Operates Class AB
    Operates Class C
    Selectable Variable Power
    Receive Pre-Amp

    Switchable Delay
    Internal Cooling Fan
    High Temperature Thermal Switch
    Thermal Switch Turns Fan On


    Rocker Switch Selects Auto or Fan On
    Laser Cut Stainless Steel Nameplate
    Laser Cut Stainless Steel Backplate
    Front Panel Blue LED Backlight
    Lighted Color Pushbutton Switches
    Meter Lights on Transmit
    Meter Scale For Relative RF Output
    Meter Scale For Battery Voltage
    1-Amp Fused Radio Connector
Manufacturer Refurbished Texas Star DX 1600 Mobile
Our Price: $1,050.00

  • 100W Input
  • 1200W Output
  • 8-TOSHIBA 2SC2879
  • SSB Delay
Unit is manufacturer refurbished from Texas Star using 8 TOSHIBA 2SC2879 transistors

*These units are for industrial, scientific, medical, or export use only. It is a violation of US FCC regulations to operate these units on the Citizens Band or Amateur Radio Services in the United States. Please check regulations in your country before operating these unit.