SymbiLink cables allow you to connect ZAPCO audio components and convert a standard unbalanced audio signal into the
fully balanced domain usually only reserved for the type of expensive professional equipment found in recording studios or
at your local concert venue. With this type of cabling in your component system it virtually becomes immune to electrical
interference in the surrounding environment and much less susceptible to signal degradation over long cable runs. It is for
this reason that balanced signal cables are common in professional or industrial applications. ZAPCO has made this
technology available for your car. ZAPCO engineers also discovered that a significant amount of low frequency distortion
was caused by the pulsating DC current in the automobile chassis, and amplifier power wiring. ZAPCO's balanced
SymbiLink technology completely eliminates this distortion.- 18 foot long SymbiLink cable
-
DIN to DIN connectors
|
- 20ft. 8 Gauge Red Power Wire
- 4ft. 8 Gauge Black Ground Wire
- 20ft. 16 Gauge Blue Remote Turn-On
- 20ft. 12 Gauge Stereo Speaker Wire
- 20ft. Stereo RCA Audio Cable (Male to Male)
- 6ft. Black Split Loom Cable Conduit
- AGU Type 60A Gold Plated Fuse
- In-Line Water Resistant Fuse Holder
- 2 Ring Terminals: 8G
- 2 Spade Terminals: 8G
- 5 Spade Terminals: 14-16G
- 3 Butt Connectors
- 20 Cable Ties
- 1 Black Grommet
|
- 21ft. 4 Gauge Red Power Cable
- 4ft. 4 AWG Clear Black Ground Cable
- In-Line Water Resistant Fuse Holder
- 80 Amp AGU Fuse Included
- 20ft. Clear Green Twisted Pair Stereo RCA Interconnect Cable
- 20ft. 16 AWG Clear Stereo Speaker Cable
- 17ft. Blue Remote Cable
- 6ft. Split Loom Cable Conduit
- Power Distribution Block, Gold
- 4 AGW Ring Terminal, 2 pcs
- 4 Spade Terminal, 2 pcs
- 2- 4 AGW Ring Terminals
- 16-14 AGW Spade Terminals 4 pcs
- 10- Cable Ties, 7''
|
